Making 3-tier architecture design to install the Microsoft Dynamic Nav 2009 RTC

Asked By shanninfortuno 0 points N/A Posted on - 02/21/2012

Hello

In one of our high-end server, I tried to install Hyper-V server. I wanted to build 3 special servers in it. The entire installation procedure of the three servers finished. But while I start the servers just 2 servers are working at the same time. I am unable to run the third server and facing an error message. Is there any restriction on amount of servers?

I was trying to make 3 – tier architecture design to install the Microsoft Dynamic Nav 2009 RTC.

The error message is as follows:

An error occurred while attempting to change the state of virtual machine (VM Name)

"(Vm name)" failed to initialize.

Need your help. Thanks in advance.

• Status: Open
• Question Views: 1172
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Email Servers

Answered By Iamexpert 0 points N/A #97450

Making 3-tier architecture design to install the Microsoft Dynamic Nav 2009 RTC

Hi 

 

The problem you are facing is that the server you are making is basically 3 servers base connection and you are running both 3 servers the 2 servers are running properly but the 3rd server is not working properly this is due to:

1. You cannot run 3 servers in this way you have to make the default server 1 and make 2 and 3 server under that server and run in this way first run 1 server which will act as parent server and then run 2 and 3 server which his child server so in this way this will start running and you will able to run 3 servers at a time but the parent child formation base. Hope this solution will help you getting out of this problem.

About Iamexpert

Questions
0

Answers
195

Best Answers
34

• Vote Up 0 Vote Down

• Posted on - 02/22/2012
• Question Category: Email Servers