Error configuring Norton Ghost 14 – Error E1AD3212

Asked By Jared T 0 points N/A Posted on - 11/12/2011

Hi Experts,

I was configuring Norton Ghost 14 when I got this error message, see below.  I was already using the administrator privileges but I still got the error message.  I got full control and rights as administrator but still I can’t configure Ghost properly. 

Any advice on what to do next?  Please help. 

Thanks in advance.

Norton Ghost

Error E1AD3212: You do not have sufficient privileges to perform this operation.

See help for more information about security settings.

• Status: Open
• Question Views: 2502
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Misc Software

Best Answer by Zorian Crust

Go To Solution

Best Answer

Best Answer

Answered By Zorian Crust 80 points N/A #109602

Error configuring Norton Ghost 14 – Error E1AD3212

Hello Jared,

I hope you're doing fine. I suggest you to follow the instructions below to solve your problem. Take note that it may lead to data expose or lost into threats online. Make back up into all your files. Make sure that your computer firewall is on.

1. Go to add/remove programs and uninstall back up exec system recovery
2. Make sure that your drivers and firmware are updated
3. Disconnect temporarily non internal attached files
4. Uninstall filter drives temporarily or perform maintenance task to remaining drives
5. Use msconfig.exe windows to start up selectively maintaining system
6. Reinstall back up exec system recovery and reboot your computer
7. Complete the installation

I hope it helps.

 

Zorian

About Zorian Crust

Questions
0

Answers
377

Best Answers
138

• Vote Up 0 Vote Down

• Posted on - 11/12/2011
• Question Category: Misc Software

Answered By The score 5 points N/A #109603

Error configuring Norton Ghost 14 – Error E1AD3212

Hi,

 

First you must do is try to download the error repair tools and then after you download you just simply try to install that to your computer and then try click the scan to start scanning your computer or software and then  after scanning your software just simply repair the found errors to your software then simply uninstall the application to your machine then try to reinstall it again into your machine then after just simply restart your computer if it’s possible then try check if there an corrupted file to your application just simply try on that.  

Ben

About The score

Questions
0

Answers
153

Best Answers
21

• Vote Up 0 Vote Down

• Posted on - 12/13/2011
• Question Category: Misc Software