Increase Speed of a Scanner

Asked By silver joson 20 points N/A Posted on - 03/26/2012

I have HP Inkjet R45, It takes too long to scan, almost 5-7 minutes, even at 200 dpi. How to increase its speed?

• Status: Open
• Question Views: 1373
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Scanners

Best Answer by Mckinney Ma

Go To Solution

Answered By Cnales Semilla 0 points N/A #101473

Increase Speed of a Scanner

Hi,

Your printer needs some adjustments to the settings, what you can do is go to the HP icon on your desktop,double click, open scanner, click on scan preferences, an adjust your speed there. If your printer was not found on your desk top then you go to start, control panel, printers and other hardware, right click, you will see properties click and ensure your printer is listed there. 

 

About Cnales Semilla

Questions
3

Answers
33

Best Answers
9

• Vote Up 0 Vote Down

• Posted on - 03/27/2012
• Question Category: Scanners

Best Answer

Best Answer

Answered By Mckinney Ma 0 points N/A #195360

Increase Speed of a Scanner

 

Hi

 

You can resolve this by changing SPP mode to ECP mode

If your parallel port is set SPP mode (Parallel port in standard bi-directional mode) your data transfer rate is very slow. So you need to change this port to ECP mode.

 

To do these changes go to “BIOS” setup & select advance setting tab then change SPP mode to ECP mode.

 

The data transfer rate for a parallel port in ECP mode is over hundred times faster than SPP mode.

Regards

Mckinney Ma

About Mckinney Ma

Questions
0

Answers
52

Best Answers
16

• Vote Up 0 Vote Down

• Posted on - 01/17/2013
• Question Category: Scanners