Unable to Sync Cortex Controller and Microprocessor

Asked By ka297e0v4 0 points N/A Posted on - 12/27/2011

I cannot sync my Cortex Controller and Microprocessor. I tried every possible solutions but I am unlucky to perform it correctly. The VEXnet Joystick and Cortex Microcontroller have a full battery charged and I successfully connect it through the USB cord. The green lights of VEXnet are active. How can I sync the two? Please help.

• Status: Open
• Question Views: 822
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Hardware

Answered By Thompson Locker 10 points N/A #156352

Unable to Sync Cortex Controller and Microprocessor

You will need to check the Cortex Controller and make sure that there are no IP addresses, MAC addresses, security settings, and IP protocols that  have been set in its implementation, for the device has been set to work wirelessly without using those settings. All you will need to do is just turn it on, and after that  it should be able to automatically connect to the correct Joystick. You should also check if the controller needs to be plugged via the VEXnet USB Adapter into your PC for programming, debugging, and driving and make sure that has been taken care of. After that you can try syncing it with the microprocessor again and see if all goes well.

-Thompson Locker

About Thompson Locker

Questions
0

Answers
619

Best Answers
77

• Vote Up 0 Vote Down

• Posted on - 12/31/2011
• Question Category: Hardware