OSD Task Sequence has failed

Asked By Laurie Kamp 0 points N/A Posted on - 07/17/2013

Hello,

OSD Task Sequence has failed with the error code 0x00000001 Task Sequence has failed with the error code 0x00000001 when running Task Sequence in WinPE mode. I tried to search the solution to fix this error but couldn’t find a resolution. Have you any idea to resolve this error? Waiting for the solution.

Thanks.

Error: Task Sequence: Re-Build x86-Newbuild has failed with the error code (0x00000001). For more information, please contact your system administrator or helpdesk operator.

• Status: Open
• Question Views: 6416
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Software

Answered By Nichols Fryman 15 points N/A #176402

OSD Task Sequence has failed

Hi Laurine,

The error is because the task sequence has a task in WinPE to install a software.
To resolve this error follow the steps below:
1) If an application need to run in WinPE two options are possible as follows:
a) If the app is small or a command line, then add it to boot image. Create a task to execute command line
b) Do a XCOPY of the package source to the local drive, add a task to execute the application from command line
2) After performing any of these options, the error will be resolved
 

About Nichols Fryman

Questions
0

Answers
701

Best Answers
99

• Vote Up 0 Vote Down

• Posted on - 11/04/2013
• Question Category: Misc Software