LabVIEW load error code 3 occurred

Asked By abraham abraham 0 points N/A Posted on - 10/16/2013

Hello,

My comp suddenly shut down and after restarting I couldn’t open any VI file.

I get the message shown below. Any ideas?

 LabView Generic error

An error occurred loading VI WPALGUI.vi

LabVIEW load error code 3:Could not load front pannel

• Status: Open
• Question Views: 1190
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Misc Software

Answered By Ioon Darn 0 points N/A #176863

LabVIEW load error code 3 occurred

First, download Service Pack 1 (available in http://www.ni.com/labview/). When you have installed it, it should be possible to open the corrupt VIs. The initial file will probably be corrupted because the connector pane is not working but copy the block diagram and paste it into a new VI. You should now be able to use the new VI's connector pane. You do not need the corrupted file anymore, so you can delete it.

About Ioon Darn

Questions
0

Answers
66

Best Answers
3

• Vote Up 0 Vote Down

• Posted on - 10/18/2013
• Question Category: Misc Software