IP Routing in Windows 2008 Server

Asked By sitsarddilag 0 points N/A Posted on - 10/06/2011

Thank you for viewing the question and thanks in advance for the help. I need assistance in setting up IP Routing (Dynamic Routing and Static Routing) in Windows 2008 Server? Also, can you please direct me how to use the RIP router to add networks?

• Status: Open
• Question Views: 1147
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Windows 2008

Answered By smithgood 0 points N/A #120776

IP Routing in Windows 2008 Server

Yes dear i have an answer or solution of your question, i m sure that you will satisfy by it. It is not an easy task so whatever if you want a solution of your problem you can read here answer of your question. In IP Routing in Windows Server 2008 in case of static routing must be make an entry in your windows it will be routed for every network.

 

It is not a new one because we use it from many years. By using the route command or GUL you can configure it in windows 2008 server, while use of route command is a best option as compare to another one. So use the route print command and than add a static route click on ok and now delete the static route.

 

These are the basics of the configuring it. For Dynamic routing must be install the routing and remote access and also visit this site.

About smithgood

Questions
0

Answers
19

Best Answers
7

• Vote Up 0 Vote Down

• Posted on - 10/06/2011
• Question Category: Windows 2008