How to do the configurations of the blits tone generator

Asked By Kennedy Rudy 0 points N/A Posted on - 11/08/2012

 

Hi

I have a bits tone generator at my workplace. The model is blits ATG202. I do not know anything about this equipment and how to use it. I ant to know how can I use this and what are the basic configurations of this.

Thank you

 

• Status: Open
• Question Views: 856
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Hardware

Best Answer by Deborah Antoaneta

Go To Solution

Best Answer

Best Answer

Answered By Deborah Antoaneta 0 points N/A #140037

How to do the configurations of the blits tone generator

Hi Kennedy Rudy,

• It is caters for 2, 4, 6, and 8 channel configurations and every one have audio tone sequences each channel configuration.
• The configuration can be cycled through automatically, or selected manually.
• And you can repeat patterns of tone.
• There is a  bank of 4 push buttons on the front panel sets these options and associated LEDs indicate the current setting.
• It is available in two variations, each providing both analog and digital audio outputs.
• Fit Redbox range in your installation only once. 

About Deborah Antoaneta

Questions
3

Answers
81

Best Answers
13

• Vote Up 0 Vote Down

• Posted on - 11/08/2012
• Question Category: Hardware

Answered By Mehdy Blancha 0 points N/A #140038

How to do the configurations of the blits tone generator

 

Hi,

It is a tone generating device for providing the line detection in Surround Sound fonts. The distinct setup of it can be used to identify stereo, channel phase etc. can also use as a switching device for stereo to 5.1 sound systems or reverse. The looping can be done through it in 5.1 system:

With “Tone output Select” selected to 5.1 and :5.1 cycle” selected to Normal, the BLITS tone generator will output the following tone sequences:

Left/Right identification: 1 kHz 0 dBu tone on both Left and Right channels, with four interruptions will differentiate the ident from the standard EBU or GLITS tones.

Phase check : 2 kHz tone at-6 dBu on audio channels.

Channel identification : The sequence is:

(Front) Left – 880 Hz

(Front) Right – 880 Hz

Centre – 1318.51 Hz

LFE – 82.407 HZ

Left Surround – 659.255 Hz

Right surround – 659.255 Hz

These frequencies correspond to notes A4, A4, E4, E0, E3, and E3 respentively.

The Blits generator may be locked into any one of these cycles using the 5.1 cycle push button.

About Mehdy Blancha

Questions
2

Answers
157

Best Answers
28

• Vote Up 0 Vote Down

• Posted on - 11/08/2012
• Question Category: Hardware