Corel Photo Pro Failed to initialize’

Asked By n1v7acute 0 points N/A Posted on - 12/24/2011

Hi all,

I have downloaded and installed ‘Photoscape’. The Coral Photo Pro was already installed by me.

But when I am clicking on the shortcut it gives an error message which says that ‘Failed to initialize’.

I have done this with my new computer which runs with Windows Vista.

Please help me to find out the problem.

Thanks in advance.

• Status: Open
• Question Views: 858
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: ProgScripting Languages

Answered By Crawly math 5 points N/A #95843

Corel Photo Pro Failed to initialize’

The minimum requirement for running Phtoscape is XP / 2000 / ME / 9x. Currently there is no Photoscape version available which runs in windows vista or 7 smoothly. My recommendations are:

1. In Windows vista or 7, right click the Photoscape setup file. Now, click ‘Run as administrator’. When the setup is done, right click the Phtoscape EXE file, and click on the properties option. Click on the compatibility tab. Now, in the upper side, change the compatibility to Windows XP service 2. In the lower side, click the ‘Run as Administrator’ option. Click on Apply then OK.

2. Change your Operating system to Windows XP and then install the Photoscape software.

Regards 

Crawly Math

About Crawly math

Questions
2

Answers
89

Best Answers
29

• Vote Up 0 Vote Down

• Posted on - 12/24/2011
• Question Category: ProgScripting Languages