StrucPLUS Precast fails to create shop drawing

Asked By Amy Bate 40 points N/A Posted on - 08/17/2012

I am having problem to create and draw with StrucPLUS Precast Panel Detailer. Someone please tell me the solution, what should I do to avoid this error message?

AutoCAD Message

Cannot find the specified drawing file.

Please verify that the file exists.

• Status: Open
• Question Views: 1387
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Photos / Graphics Soft.

Answered By Hathy greave 0 points N/A #132221

StrucPLUS Precast fails to create shop drawing

Hi,

Since you see the message, you have to think that the common reason is the WBLOCK doesn't work properly, showing the following error message on the command bar:

"wblock operation rejected due to a proxy object that does not allow copying"

In this regard the drawing contains protected block. 

Just unblock it and your problem will be solved.

You can do another thing. It's very easy. Just install the latest service pack from autodesk website. It also works.

Thanks

Hathy

About Hathy greave

Questions
2

Answers
147

Best Answers
27

• Vote Up 0 Vote Down

• Posted on - 08/17/2012
• Question Category: Photos / Graphics Soft.