TV VCR receiver Troubleshooting kindly reply

Asked By Allushe 0 points N/A Posted on - 01/23/2012

I want to set the input selection on my receiver and I want to make HDMI as the default one. When turning it off, and then turn it on again, it is set to the default connection.  

However, when I turned the receiver off for more than 10 seconds, it will be set to TV/SAT.

How can I make it firm and set the receiver to HDMI automatically?

Please help.

• Status: Open
• Question Views: 979
• Answer Count: 2
• Vote Up 0 Vote Down

• Answer Accepted: Yes
• Question Category: Hardware Components

Best Answer by Benson Sale

Go To Solution

Best Answer

Best Answer

Answered By Benson Sale 5 points N/A #124310

TV VCR receiver Troubleshooting kindly reply

Dear Friend!

If you see your owner’s manual chapter four, you can find the procedure to setup with detailed description. Default settings are written in the page number 41 in the above mentioned manual. This is my recommendations that you set the default settings in input selection at your initial stages.

Hope you can better start with the help of manual, manual can be download from it’s official website.

Thanks,

About Benson Sale

Questions
0

Answers
25

Best Answers
14

• Vote Up 0 Vote Down

• Posted on - 01/23/2012
• Question Category: Hardware Components

Answered By Bonnie Misty 0 points N/A #124311

TV VCR receiver Troubleshooting kindly reply

 

Please download the manual and find there the complete procedure. You can find it on the Internet. For example, you can search on http://tv.manualsonline.com/manuals/device/tv_vcr_combo.html and select there the specific type of device you own.

About Bonnie Misty

Questions
2

Answers
36

Best Answers
1

• Vote Up 0 Vote Down

• Posted on - 10/24/2012
• Question Category: Hardware Components