Solve Chassis Intruded Fatal Error System Halted Solution Manually.

Asked By 0 points N/A Posted on -
qa-featured

Hi all,

I am using ASUS Mother Board on my computer. When I opened the system, it showed the chassis intruded fatal error system halted solution error. I am now only able to enter the BIOS of computer. Does anybody know what to do?

SHARE
Answered By 0 points N/A #293763

Solve Chassis Intruded Fatal Error System Halted Solution Manually.

qa-featured

Just follow these simple steps and check If the error still appears.

Make sure that the Mother Board must be out of electricity in all of these below steps.

  1. Check whether the Chassis of your PC is closed. A sensor on your chassis must bein push state while closing the cover.
  2. If the problem persists, then check the Chassis Intrusion Jumper on the Mother Board. A jumper must be placed between Pin-2 and Pin-1. Now, this is the correct jumper position to deactivate the chassis intrusion option. Then, dispatch the CMOS battery, clear CMOS settings by keeping the CRLTC jumper on pin 3 and pin 2 for about 10 seconds and then again place it between Pin 2 and Pin 1. Next, put the CMOS battery. Start your pc and again check if the problem persists.
  3. If none of this work, then try this. You should have some electronic repair knowledge on removing dead Micro Chips.

Try to turn on the computer then and open BIOS. In the BIOS default settings choose Option “directly into Windows.” Setup Time, Date and First Boot option and then Save & Exit.

Related Questions