How to make a network cable

Asked By Chuck Moose 0 points N/A Posted on - 03/23/2012

 

I want to know how to make a network cable?

If you can tell me the whole process of it and how many hours it will take me to do it?

• Status: Open
• Question Views: 989
• Answer Count: 1
• Vote Up 0 Vote Down

• Answer Accepted: No
• Question Category: Telecommunications

Answered By Heather marie 0 points N/A #119905

How to make a network cable

Hi,

How to make a Network Cable:

1. Untie the necessary length of network cable and insert a small wire.
2. Cautiously take out the external jacket of the cable.
3. Examine the recently exposed wires for some cuts or scratch that depicts the copper wire within.
4. Loosen the pairs so they will put down flat among your fingers.
5. Position the wires according on the wiring qualifications you are tracking.
6. Push all the wires flat and in array as you press them into the RJ-45 plug with the flat face of the plug on top.
7. Put the wired plug up into the crimping device.
8. Repeat all steps with the new end of the cable.
9. Check the cable to make sure that it will function.

 

Best regards,

Heather marie

About Heather marie

Questions
3

Answers
296

Best Answers
61

• Vote Up 0 Vote Down

• Posted on - 09/10/2012
• Question Category: Telecommunications