When I place my both rams in my main board , pc starts but shows black screen but when I take one of them, then it works fine.
I checked both rams respectively and both work fine when they are used separately.
Is there any solution to use both rams at a time?
Do you have any extra ram that you can test in those slots?
Anyway, it seems not as much worse as facing difficulties. I had worked on my friend’s PC, they somehow entered the masking tape in those ram slots, so when I tried to take them out, a huge amount of elements gets entered into the slot. I have to spend enough time with a toothpick to ensure the removal of those particles from the slots.
Otherwise the slots will be left nonoperational.
It is not possible for you to look into the slots, but you can have a look in motherboards. If the faculty operates in the red slots then it must be clean, did not messed up. Can you tell me the model of your motherboard so that it could help us sorting out the problems?
Nothing To Worry.
Your Both Rams Can Work Individually,
They're Not Working At Same Time Cause They're DisMatching !
IF Your Both Rams Are 512 MB Then Give it to Any Hardware Technical And Make it 1GB As 1 Ram 🙂
DisMatching Problem Can't Be Resolve !
Â
Hi good day
Both of your Ram is ok
But the problem is one of your memory card is not working properly or one of that is damage.
To resolve that kind of issue, select the good memory card and replace the damage memory card
NOTE
Make sure the memory card you use is compatible to the system hardware.
Thank you, hope its help
Best regards;
Gracejov
Hello Dear,
It seems that you have a problem with your second RAM slot.
Take one RAM and test it in both slots by running a PC check.
If the PC does not display the RAM from both slots, you should contact a technician, and if it does display, then it is possible that your RAMs have different bus speeds, and RAMs having different bus speeds creates these problems.
I hope this helps you.
Thanks.
Â
