How can I wake up a remote computer using wake up packets? Can Do I need to run special command to wake up the computer from sleep? I want to be able to stream less connect to my computer despite the power saving measures that are in place when its idle.
Waking up a computer using magic packets to establish a connection
HELLO
Â
There are following steps for wake up a computer using magic packets
Â
To open the network and sharingÂ
Click to the start button
You need to search the network and sharing from the start box.
And then press enter.
After that you need to change the adapter settings at the upper left of the navigation .
Then you need to right click on the network connections for enable the power management .
After that you need to click on properties and configure.
Power management tab will be open and check/clear is allow the computer to shut down of this device for saving the power check box.
Whenever power management ,Checked is enabled to network adapter.
Whenever  power management , Cleared is disabled to the network adapter.
You can have enabled to wake on LAN for all methods of LAN or just enable magic packet.
It will enable all the wake of all methods of LAN, After that you need to allow the device to wake the computer check box.
After that you need to enable the magic packet for LAN only and allow the device to wake the computer and also allow to the magic packet to wake the computer check box.
Then click on the ok.